Description
This oil/fuel pressure sensor will allow a high-quality aftermarket engine management system to monitor oil pressure and take immediate action or sound alarms if a fault condition is encountered.
For example, on a Link G4+ or G4X the smart limits can be set up by entering the minimum oil pressures for each engine speed range. If the oil pressure drops below the threshold for the current engine speed, then the ECU can automatically limit the engine speed to any desired rpm (e.g limp home mode). Features such as this save engines time and time again. But in order to perform these features the ECU does need the appropriate oil pressure sensor.
This oil / fuel pressure sensor utilizes a M10 x 1.0 thread, but is available with 2 adapter options:
- M10 x 1.0 to 1/8″ NPT male thread adapter, or;
- M10 x 1.0 to AN-3 Teflon hose end adapter, with stainless steel mounting kit
Both options include the 3 pin connector kit (contains connector housing, terminals and seals)
Most aftermarket ECUs allow the sensor calibration data to be entered via the tuning software. The linear calibration for this particular sensor is:
0.5V = 0 kPa (gauge)
4.5V = 1000 kPa (gauge)
Pinout:
Pin 1 = 5V
Pin 2 = Ground
Pin 3 = 0.5 to 4.5V signal
