Description
Link CAN Connection Cable for G4X/G4+ Wire-in ECU’s with Round CAN Connector – CANLTW
This cable is used when connecting a digital dash or any other device via CAN-bus to a Link G4+ / G4X wire-in ECU which have the 6-pin Round CAN Connector just below the tuning port.
Compatible ECU’s:
- G4X/G4+ Fury (CAN1)
- G4X/G4+ Xtreme (CAN1)
- G4+ Force (CAN1)
- G4+ Thunder (CAN1)
The two CAN wires (CAN-HI, CAN-LOW) are terminated to the 6-pin round LTW connector.
In order to supply power and ground to the devices(s) on your CAN-bus, power and ground wires are also included in the loom in the form of a flying lead approximately 500mm long.
These four wires are then terminated to a 4-way Deutsch DTM connector at a length of approximately 300mm. This provides enough length for the loom to exit the ECU, and the Deutsch connector allows for the ECU to be disconnected from the vehicle easily. The mating side of the 4-way Deutsch DTM connector can also be supplied as an optional variation (connector housing, terminals and wedge).
