Description
ZF Electronics / Cherry GS101205 Hall Effect Speed & Cam/Crank Position Sensor with Connector
When combined with a pull-up resistor, hall-effect sensors such as this one output a digital signal (high or low) and can be triggered using a ferrous steel toothed trigger wheel. Because the output signal amplitude is not dependent on the speed of the trigger wheel, hall-effect sensors do tend to measure very low speeds more accurately than reluctor sensors.
Suitable for Transmission Speed, Wheel Speed and Engine Cam/Crank Position
- Operating Voltage Range = 5 to 24 VDC (max. 30 VDC)
- Supply Current = 6 mA max
- Operating Temperature = -40deg to 150deg Celsius
- Includes 3-pin Pull-to-Seat Connector
Recommended External Pull-Up Resistor:
Volts DC 5 9 12 15 24
Ohms 1k 1.8k 2.4k 3k 3k
Installation:
Typical air gap of 1.5 mm
